Falco Flash BLE 4.0

Falco Flash BLE 4.0 is available with support latest Android version Pie.

To increase the Motor Power Level by 1, swap the finger in upward direction on screen (swap length should be more than 1 inch) when Motor is connected.

To decrease the Motor Power Level by 1,swap the finger in downward direction on screen (swap length should be more than 1 inch) when Motor is connected.

To connect and Disconnect Falco Flash to any Falco motor can be done by single Button(White/blue round color Button on First screen-White for Start ,Blue for Stop)

To have an Emergency Stop on Motor while running can be done by Emergency Stop(Red Color) button which is available on first screen.(whenever we click on Emergency Stop button it divert motor power level to power level -3)

Display total Duration of time for which Falco Flash has been connected to Motor.

Display the Battery voltage in graphical form.(Minimum battery voltage should be 30V, if battery voltage goes below 30V it shows empty battery level in red color).

Display of Battery Capacity and iWatts.

Display of battery WH/Miles.

Display of battery WH/Miles remaining.

Display of ODO(Distance) meter using Miles unit.

Display Motor Temperature/Power Level.

Torque Sensor Settings Screen will display -

Turn ON Speed

Base Torque

Flip Axle

TS Turn ON

Turn ON Delay

Turn OFF Delay

Torque Multiplier

Dropout Offset

You can broadcast,memory read or restore these motor values.

Torque Sensor parameters screen will receive below parameters ->

TS Raw

TS Rectified

TS Peak

TS Final

Power Configurator Screen ->

Provided current clamp settings for Assist or Regen mode with seek bar to each power level.

You can broadcast,memory read and restore these values.

Settings option (Menu) ->

This option is available at top right corner displaying three vertical dots or hardware option menu depending on device.

-Motor ID Settings

-TS ID Settings

-CRM Settings

-Device Information

-Battery Type

-Sensor Selection

- Auto read at start(firmware, battery and sensor selection)

- Support added for 101183, 101138 and 101395 firmware