Dr.OnOff (Trial)

Điều khiển từ xa cho UniPi (EVOK), Raspi + PiFace kỹ thuật số 2 & Pollin AVR-NET-IO

* Control the outputs and inputs of your UniPi (EVOK) device, Raspberry with PiFace Digital2 or Pollin AVR-NET-IO easily.

* UniPi (EVOK) support (e.g. UniPi Neuron): analog and digital outputs, relays, analog and digital inputs, sensors of type dev=temp (e.g. 1-wire sensors)

* This trial version works 24 hours!

Features:

- Configure multiple profiles (Name, IP, Port)

- Name your outputs and inputs

- Outputs can behave as switch or push button

- Push button mode: define min and max switching times

- Read inputs manually or continously

- Different layouts for tablets und phones

- Phone: swipe left/right to change the view (inputs or outputs)

- Switch device by swiping up or down

- Change background and text colors for each device

- Password protection for all settings

Feedback goes to: [email protected]

-----------

Raspberry Pi with PiFace Digital 2 how to:

http://www.bsc101.eu/dronoff/pifaceguide.html

1) Setup Raspberry Pi and PiFace Digital 2 (raspi-config -> enable SPI)

2) Install these python libs:

sudo apt-get install python{,3}-pifacedigitalio

sudo apt-get install python{,3}-pifacecommon

3) Download this python script: http://www.bsc101.eu/dronoff/dronoff3.py

4) Run the script dronoff3.py on the Raspberry: python3 dronoff3.py

5) Add a device in the app, use the IP of your Raspberry and port 50290 (you can change the port in the script), set Board to Raspberry Pi + PiFace Digital 2

If you have any questions, please contact: [email protected]

Disclaimer:

The provider of this app is not responsible for any damages caused by using this app!